For the digital cameraStylus 600/µ DIGITAL 600 Thank you for buying the Underwater Case PT-029. Please read this instruction manual carefully and us
E-91. PreparationsCheck the contents of the package.Check that all accessories are in the box.Contact your dealer if accessories should be missing or
E-10Names of the partsNote :The Case operation parts marked by ❈ corresponds to the operation partsof the digital camera. When the operation parts of
E-11Install the strap on the Case body.:Please install the strap correctly as shown above. OLYMPUSIMAGING CORP. shall bear no responsibility for damag
E-12How to Press the ShutterWhen pressing the shutterlever, press it gently, so thatthere will be no movement ofthe camera.Note: • For detailed operat
E-132. Advance Check of the CaseAdvance test before useThis Case has been the subject of thorough quality control for theparts during the manufacturin
E-143. Install the digital camera.Check the digital camera.Check the digital camera before loading it in the Case.Battery ConfirmationAs the LCD monit
E-15Prepare the camera.Which digital cameras can be used?This Case (PT-029) can only be used with the Stylus 600/µ DIGITAL600 camera.Turn on the camer
E-16Make sure the digital camera is turned off, then insert it gently intothe case.:•If the digital camera is not inserted properly, it may notbe poss
E-17Insertion of silica gelBefore sealing the Case, insert the accessory silica gel bag forprevention of fogging between the bottom of the camera and
E-18Seal the Case.Check the loading status.:•Seal the Case by turning both buckle lock levers downin arrow direction. When one of the buckles is lefto
E-1Introduction● Unauthorized copying of this manual in part or in full, except forprivate use, is prohibited. Unauthorized reproduction is strictly p
E-19After sealing the case, perform the following final checks to confirmproper operation of the camera. Push the POWER ON/OFF button on the case to
E-20Installation and Removal of the LCD HoodInstallationStrongly push the mounting projections of the LCD hood as shownin the figure into the guides a
E-21Perform the final checks.Visual InspectionAfter sealing the Case, check the sealing part of front and rear lidvisually to confirm that the O-ring
E-22Now everything is all right!Have a nice dive!Final TestThe final test after loading the camera is explained below. This is the only way toeliminat
E-234. Taking Pictures Under WaterHow to Use the Hand StrapPass your hand through the accessory hand strap and adjust thelength with the stop button.T
E-245. Underwater Shooting According to the Scene TypeUnderwater shooting modesSuitable for shooting a scene thatextends across a wide range such as a
E-25Selecting the shooting scene mode Shooting scene display Shooting scene mode selection OK/MENU buttonPress the Shooting mode/SC
E-266. Handling After ShootingWipe off any waterdrop.After completing the shootingand returning to land, wipe offany waterdrop sticking to theCase. Us
E-27Take out the digital camera.Open the Case carefully and take the digital camera out.:•Always place the opened Case with the O-ring sidefacing up.
E-28Wash the Case with pure water.After use, seal the Case again after taking out the camera and wash itsufficiently in pure water as soon as possible
E-21. Keep this product out of the reach of babies, infants, and children.There is the possibility of occurrence of the following types ofaccidents.
E-297. Maintaining the Waterproof FunctionRemove the O-ring.Open the Case and remove the O-ring from the Case.Removal of the O-ring Insert the O-ring
E-30:•When a mechanical pencil or a similar other sharp objectis used to remove the O-ring or to clean the inside of theO-ring groove, the Case and th
E-311Install the O-ring.Confirm that no foreign matter is attached, apply a thin coat of theaccessory grease to the O-ring, and fit the O-ring into th
E-32Replace consumable products. The O-ring is a consumable product. Independent of the number oftimes the Case is used, it is recommended that the O
E-338. AppendixQ & A on the use of the PT-029Q1 :Which digital cameras can be used?A1 :The The PT-029 is only for the models Stylus 600/µ DIGITAL
E-34(3)In case of the following handling with a camera loaded into theCase, trouble or breakage may be caused for the Case and/orthe loaded camera. Al
E-35of the Case and deterioration of the O-ring. Wipe the inside of the Casewith a soft cloth not causing any fibers. Remove the O-ring, wipe off anys
E-36(7)Throwing the Case from a boat into the water, jumping with the Caseinto the water, or other sudden application of strong forces onto theCase. W
E-37Olympus defogging silica gel.•Do not use adhesive for repairs or other purposes. When repair isrequired, please contact a service station of our c
E-38Specifications❈ We reserve the right to change the external appearance and thespecifications without notice.Available modelsOlympus digital camera
E-3Batteries● Please use one Olympus lithium ion rechargeable battery forcameras (LI-12B).● Take care that the battery electrodes do not become wet. T
http://www.olympus.com/¤2005Shinjuku Monolith, 3-1 Nishi-Shinjuku 2-chome, Shinjuku-ku, Tokyo, JapanTwo Corporate Center Drive, P.O. Box 9058, Melvi
E-4When water leakage occurs while this product is being used, repair of thecamera housed in this product may become impossible. Please observethe fol
E-5Handling the Product● Use or storage of the product at the following locations may causedefective operation, defects, trouble, damage, fire, intern
E-6● Do not perform operations other than specified in this instructionmanual, do not remove or modify parts other than specified, and donot use parts
E-7Introduction ......E-1Please read the following items before use ...
E-8Installation and Removal of the LCD Hood .........E-20Installation ...............
Comments to this Manuals