Olympus SH-2 Instruction Manual Page 110

  • Download
  • Add to my manuals
  • Print
  • Page
    / 119
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 109
110
EN
FCC Caution
FCC Caution
Changes or modi cations not expressly approved by the party responsible for compliance could void the user’s
authority to operate the equipment.
This transmitter must not be co-located or operated in conjunction with any other antenna or transmitter.
The available scienti c evidence does not show that any health problems are associated with using low power
wireless devices. There is no proof, however, that these low power wireless devices are absolutely safe. Low
power Wireless devices emit low levels of radio frequency energy (RF) in the microwave range while being used.
Whereas high levels of RF can produce health effects (by heating tissue), exposure of low-level RF that does
not produce heating effects causes no known adverse health effects. Many studies of low-level RF exposures
have not found any biological effects. Some studies have suggested that some biological effects might occur, but
such ndings have not been con rmed by additional research. SH-2 has been tested and found to comply with
FCC radiation exposure limits set forth for an uncontrolled environment and meets the FCC radio frequency (RF)
Exposure Guidelines.
This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment and meets
RSS-102 of the IC radio frequency (RF) Exposure rules. This equipment has very low levels of RF energy that are
deemed to comply without testing of speci c absorption ratio (SAR).
For customers in North America, Central America, South America and the Caribbean
For customers in North America, Central America, South America and the Caribbean
Declaration of Conformity
Model Number: SH-2
Trade Name: OLYMPUS
Responsible Party:
Address: 3500 Corporate Parkway,
P.O. Box 610, Center Valley,
PA 18034-0610, U.S.A.
Telephone Number: 484-896-5000
Tested To Comply With FCC Standards
FOR HOME OR OFFICE USE
This device complies with Part 15 of FCC Rules and Industry Canada licence-exempt RSS standard(s). Operation
is subject to the following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference that may cause undesired operation.
This Class B digital apparatus complies with Canadian ICES-003. CAN ICES-3(B)/NMB-3(B)
OLYMPUS AMERICAS LIMITED WARRANTY - OLYMPUS IMAGING AMERICA INC. PRODUCTS
Olympus warrants that the enclosed Olympus® imaging product(s) and related Olympus® accessories
(individually a “Product” and collectively the “Products”) will be free from defects in materials and workmanship
under normal use and service for a period of one (1) year from the date of purchase.
If any Product proves to be defective within the one-year warranty period, the customer must return the defective
Product to the authorized Olympus Repair Service Center designated by Olympus, following the procedure set
forth below (See “WHAT TO DO WHEN SERVICE IS NEEDED”).
Olympus, at its sole discretion, will repair, replace, or adjust the defective Product at Olympus’s cost, provided that
an Olympus investigation and factory inspection disclose that (a) such defect developed under normal and proper
use and (b) the Product is covered under this limited warranty.
Repair, replacement, or adjustment of defective Products shall be Olympus’s sole obligation and the customer’s
sole remedy hereunder.
Repair or replacement of a Product shall not extend the warranty period provided herein, unless required by
law. Except where prohibited by law, the customer is liable and shall pay for shipment of the Products to the
designated Olympus Repair Service Center.
Olympus shall not be obligated to perform preventive maintenance, installation, deinstallation, or maintenance.
Olympus reserves the right to (i) use reconditioned, refurbished, and/or serviceable used parts (that meet Olympus’s
quality assurance standards) for warranty or any other repairs and (ii) make any internal or external design and/or
feature changes on or to its products without any liability to incorporate such changes on or to the Products.
Page view 109
1 2 ... 105 106 107 108 109 110 111 112 113 114 115 ... 118 119

Comments to this Manuals

No comments