Instruction ManualWaterproof CasePT-018For the digital cameraCAMEDIA C-740 Ultra Zoom/C-750 Ultra Zoom Thank you for buying the Waterproof Case PT-018
E-91. PreparationsCheck the contents of the package.Check that all accessories are in the box.Contact your dealer if accessories should be missing or
E-10Names of the partsNote:The Case operation parts marked by※ corresponds to the operation parts ofthe digital camera. When the operation parts of th
E-11Install the strap.Install the strap on the Case body.:Please install the strap correctly as shown above. Our companyshall bear no responsibility f
E-12How to Press the ShutterWhen pressing the shutterlever, press it gently, so thatthere will be no movement ofthe camera.Note:・For detailed operatio
E-13Setting the Zoom LeverWhen loading the digitalcamera in the Case, fit theprojecting part of the zoomlever of the digital camera intothe rec
E-142. Advance Check of the CaseAdvance test before useThis Case has been the subject of thorough quality control for the partsduring the ma
E-153. Install the digital camera.Check the digital camera.Check the digital camera before loading it in the Case.Battery ConfirmationSince the LCD mo
E-16Check the operation of the camera.Confirm the operation according to the instruction manual for the digital camera.Load the digital camera.Open th
E-17Insertion of silica gelPay attention to the orientation.Before sealing the Case, insert the accessory silica gel bag (for preventionof fogging) be
E-18:・Seal the Case by turning both buckle lock levers down inarrow direction. When one of the buckles is left open, theCase will not
E-1Introduction●Unauthorized copying of this manual in part or in full, except for privateuse, is prohibited. Unauthorized reproduction is
E-19Installation and Removal of the LCD HoodInstallationStrongly push the mounting projections of the LCD hood as shown in thefigure into the guides a
E-20Perform the final checks.Visual InspectionAfter sealing the Case, check the sealing part of front and rear lid visuallyto confirm that the O-ring
E-21Final TestThe final test after loading the camera is explained below. This is the only way toeliminate worry about possible entr
E-224. Taking Pictures Under WaterHow to Use the Hand StrapPass your hand through the accessory hand strap and adjust thelength with the stop bu
E-235. Handling After ShootingWipe off any waterdrop.After completing the shooting andreturning to land, wipe off anywaterdrop sticking to the Cas
E-24Take out the digital camera.Open the Case carefully, pull up the mode dial from the upper surface of theCase to disengage it from the mo
E-25Wash the Case with pure water.After use, seal the Case again after taking out the camera and wash itsufficiently in pure water as soon a
E-266. Maintaining the Waterproof FunctionRemove the O-ring.Open the Case and remove the O-ring from the Case.Removal of the O-ring①Insert the O-ring
E-27Install the O-ring.Confirm that no foreign matter is attached, apply a thin coat of the accessorygrease to the O-ring, and fit the O-ring into the
E-28Replace consumable products.・The O-ring is a consumable product. Independent of the number of timesthe Case is used, it is recommended that the O-
E-21.Keep this product out of the reach of babies, infants, and children. Thereis the possibility of occurrence of the following types of accidents.・I
E-297. AppendixQ & A on the use of the PT-018Q1:Which digital cameras can be used?A1:The PT-018 is only for the models C-740 Ultra Zoom/C-750 Ultr
E-30(3)In case of the following handling with a camera loaded into the Case,trouble or breakage may be caused for the Case and/or the lo
E-31Wipe the inside of the Case with a soft cloth not causing any fibers.Remove the O-ring, wipe off any salt, sand, dust, etc., and al
E-32(6)Catching of the strap, the bag of silica gel, etc. at the time of sealing theCase.(7)Throwing the Case from a boat into the water, jumping wit
E-33・Do not use anticorrosion agents on the metal parts. The metal parts aremade of aluminum, brass or stainless steel. Cleaning with pure water issuf
E-34After-sale Service●You will receive the guarantee card from your dealer. Please make surethat the dealer's name, the date of
E-35Specifications※We reserve the right to change the external appearance and thespecifications without notice.Available models Olympus digital camera
MEMO
http://www.olympus.com/San-Ei Building, 22-2, Nishi Shinjuku 1-chome, Shinjuku-ku, Tokyo, JapanCustomer support (Japanese language only): Tel. 0426-42
E-3Batteries●Use either two lithium battery packs CR-V3 (LB-01 made by Olympus)or four AA alkaline or lithium or nickel-hydrogen or Nicad batteries as
E-4For Prevention of Water Leakage AccidentsWhen water leakage occurs while this product is being used, repair of thecamera housed in this p
E-5Handling the Product●Use or storage of the product at the following locations may causedefective operation, defects, trouble, damage, fire, in
E-6●Do not perform operations other than specified in this instruction manual,do not remove or modify parts other than specified, and do not use part
E-7Introduction …………………………………………………………E-1Please read the following items before use ……………………E-1For safe use …………………………………………………………E-1Batteries …………………
E-8Check the loading status …………………………………………E-18Seal the Case ……………………………………………………E-18Install the special balance weight ………………………………E-18Installation
Comments to this Manuals