Olympus MJU740 Datasheet Page 51

  • Download
  • Add to my manuals
  • Print
  • Page
    / 80
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 50
EN 51
Getting to know your camera better
Getting to know your came ra better
Getting to know your camera better
The battery is not fully charged
Charge the battery with the charger.
The battery is temporarily unable to function because of the cold
Battery performance declines in low temperatures, and the charge may not be sufficient to
turn on the camera. Remove the battery and warm it by putting it in your pocket for a while.
The camera is in sleep mode
To save battery power, the camera automatically goes into sleep mode and the monitor
turns off if there is no operation when the camera is turned on (when the lens is extended
and the monitor is on). No picture is taken even if the shutter button is fully pressed in
this mode. Operate the zoom button or other buttons to restore the camera from sleep
mode before taking a picture. If the camera is left for 15 minutes, it automatically turns
off (the lens retracts and the monitor turns off). Press o to turn the camera on.
The mode dial is set to q
This is the playback mode for displaying pictures on the monitor. Set the mode dial to a
shooting mode.
The mode dial is in the position of g
No pictures can be taken when the shooting guide is being displayed. Take pictures after
setting target terms by following the shooting guide or set it to the setting other than
g in shooting mode.
The flash is charging
Wait until the # (flash charge) mark stops blinking before taking the picture.
The memory gauge is full
No pictures can be taken when the memory gauge is full. Wait until there is space in the
memory gauge.
The camera has been used in the same conditions from the time of purchase
No date and time have been set for the camera at the time of purchase. Set the date and
time before using the camera.
g “Turn the camera on” (P. 5)
X Setting the date and time” (P. 32)
The battery has been pulled out of the camera.
The date and time settings will be returned to the factory default settings if the camera
is left without batteries for approximately 1 day. Before taking important pictures, check
that the date and time settings are correct.
Shooting tips and information
Tips before you start taking pictures
The camera does not turn on even when a battery is loaded
No picture is taken when the shutter button is pressed
The date and time have not been set
a b c d
Before taking
any pictures
(Off)
Maximum
reached
(All lit)
After taking
one picture
(Lit)
After taking
several pictures
(Lit)
Shoot Shoot Shoot
Wait
d4314_15_e.book Page 51 Friday, July 14, 2006 2:47 PM
Page view 50
1 ... 50 51 52 ... 80

Comments to this Manuals

No comments