Olympus PT 023 User Manual Page 14
- Page / 42
- Table of contents
- BOOKMARKS
Rated. / 5. Based on customer reviews
E-13
Setting the Zoom Lever
When loading the digital camera in the
Case, fit the projecting part of the zoom
lever of the digital camera into the
recessed part of the zoom lever on the
inside of the Case.
Power Switch Button Operation Method
Press the power switch button
to switch on the camera power
supply.
When the power switch button
is pressed again, the camera
power supply is switched off.
Advice
•
When loading the camera, confirm that the projecting part of
the zoom lever of the camera is properly set to the recessed
part of the zoom lever of the Case.
•
When the setting is insufficient, the loading of the camera
becomes imperfect and it may not be possible to seal the
Case or zooming may not function. Insufficient sealing will
cause water leakage.
: • When the digital camera has not been used for about 3
minutes while in the shooting mode, it enters the sleep
mode (standby status). In the sleep mode, the lens returns
to the wide-angle end and no camera operation is possible.
To cancel sleep mode (and return to operation status),
press the shutter button or any other button.
For details, refer to your digital camera's instruction manual.
CAUTION
Popping up the Flash
Press the flash button on the case to
pop up the camera’s flash.
: • Once the flash is up, it cannot be retracted as long as the
camera is in the case. Remove the camera from the case to
retract the flash.
CAUTION
Power switch
button
PT_023JE_E4.0.qxd 2004.11.2 9:48 AM ページE-13
- Underwater Case 1
- Disclaimer 2
- For safe use 2
- Batteries 4
- Handling the Product 6
- Contents 8
- 1. Preparations 10
- Names of the parts 11
- Install the strap 12
- Master the basic operation 12
- Holding the Case 12
- How to Press the Shutter 13
- How to Use the Zoom Lever 13
- How to Use the Mode Dial 13
- Setting the Zoom Lever 14
- Popping up the Flash 14
- 2. Advance Check of the Case 19
- Advance Test 20
- Check the digital camera 21
- Battery Confirmation 21
- Mounting guide rails 23
- Seal the Case 24
- Check the loading status 24
- Installation 25
- Try to move the mode dial 26
- Perform the final checks 26
- Visual Inspection 26
- Final Test 27
- How to Use the Hand Strap 28
- Take pictures carefully 28
- Caution when using the flash 28
- 5. Handling After Shooting 29
- Take out the digital camera 30
- Dry the Case 31
- Remove the O-ring 32
- Remove any sand, dirt, etc 32
- Install the O-ring 33
- Clean and apply O-ring 34
- Replace consumable products 35
- 7. Appendix 36
- After-sale Service 41
- Specifications 42
- Diver's Insurance Guide 42
Related products and manuals for Camera accessories Olympus PT 023
(7 pages)Infloor Radiateurs manuels d'utilisation
À partir de P
Comments to this Manuals