Olympus E-500 User Manual Page 173

  • Download
  • Add to my manuals
  • Print
  • Page
    / 216
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 172
173
If you encounter problems
11
Appendix
The top left part of the picture appears too bright.
When shooting at slow
shutter speeds, noise may
be generated due to a rise
in temperature in the CCD
drive circuit.
Set [NOISE REDUCTION] to [ON] before taking
pictures.
P. 95
Pictures cannot be played back on the monitor.
Pictures are not stored on
the card.
“NO PICTURE” appears on the monitor. Record
pictures.
The card error occurs. Refer to the error messages. P. 168
No picture is displayed on the TV when connected to the camera.
The video cable is not
connected correctly.
Connect the cable properly according to the
instructions.
P. 108
The camera's video output
signal is incorrect.
Set the video signal according to the region
where used.
P. 135
The TV 's video signal is
incorrect.
Set the TV to the video input mode.
The monitor is hard to see.
The brightness is not
adjusted properly.
Adjust the brightness of the monitor using the
menu.
P. 133
The monitor is exposed to
direct sunlight.
Block the sunlight with your hand.
The computer does not recognize the camera correctly.
The camera's power is
turned off.
Set the power switch to ON.
The USB driver was not
successfully installed.
Install the OLYMPUS Master. P. 155
The camera is in the
[CONTROL] mode.
Set [USB MODE] to [AUTO] or [STORAGE].
When [AUTO] is set, the selection screen for
USB connection is displayed every time you
connect the USB cable to the camera.
P. 134
Possible cause Corrective action
Ref. Page
Page view 172
1 ... 172 173 174 ... 216

Comments to this Manuals

No comments