Olympus P-400 User Manual download pdf (Page 1)

QuickStart Guide

PREPARING THE CAMERA FOR USE

Before you begin using your Olympus Digital Camera…

Charging the battery

The Digital Camera uses an Olympus Lithium ion battery (LI-10B) and dedicated charger (LI-

10C). This is the only battery/charger designed for use with the Digital Camera. The battery

cannot be charged while in the camera.

Note: The Lithium ion battery is not fully charged when the camera is

purchased. You must fully charge the battery using the charger before first use.

• Insert the Lithium ion battery into the charger as indicated in the illustration.

• Connect the battery charger AC cable as shown to a standard wall outlet.

• To fully charge the battery requires approximately 2 hours. The charge indicator light will be red

when charging, and will turn green when the charging process is complete.

Loading the battery

Note: The battery and xD-Picture card compartments are accessed by opening the

respective compartment covers.

• Slide the battery compartment cover in the direction of the arrow, and lift

open the cover as shown in the illustration. (the direction indicated by the

mark on the cover)

• Insert the battery into the compartment.

• Close the battery compartment cover so that it pushes the battery in and

slide the cover while pressing the mark.

Note: If the battery compartment cover is hard to close, do

not force it. Press on the cover firmly to close the cover,

and then slide it into position.

• To remove the battery, make sure that the monitor and the lamp at the

side of the viewfinder are off. Return the camera to the upright position

and tip the battery out.

Inserting the xD-Picture Card

The xD-Picture Card is where the camera stores your pictures and

is available in a variety of memory capacities. The pictures you take

with the camera remain on the xD-Picture Card even when the

camera is turned off and/or the battery is removed.

• Open the connector cover while pressing the mark as in the illustration.

• Open the card cover by pulling the card cover catch towards you.

• Insert the xD-Picture Card into the spring-loaded card slot as shown in

the illustration. Push the card fully into the slot. The card will lock into

place when fully inserted.

• To remove, push the card all the way in to unlock it, then let it return slowly.

• Close the card cover before closing the connector cover.

• Press to close the connector cover.

Confirm you have installed the battery and xD-Picture Card properly by

pressing . The “NO PICTURE” message should be displayed in the

monitor. Turn the camera off by pressing again.

Attaching the strap

(OPTIONAL)

Attach the strap as illustrated to make the camera easier to handle.

Charge indicator

TURNING ON THE CAMERA

All you need to do is slide the lens barrier open or close to turn the camera ON or OFF.

Turning the camera ON

(SHOOTING MODE)

• Slide the lens barrier fully until it clicks. The lens extends.

• To turn the camera off, slide the lens barrier until you feel the first click. Wait until the lens is fully retracted, then

close the lens barrier all the way.

:To maximize battery life, the Digital Camera features a power saving mode in which the camera enters a sleep mode after

approximately three (3) minutes of non-use. Press the shutter button to wake up the camera.

Setting the Date and Time

(OPTIONAL)

Set the date and time when using the camera for the first time. This affects the way image file names are

created, and will conveniently include this information with each picture.

• With the front lens barrier closed, press once. The monitor will turn on with “NO PICTURE” displayed in the

monitor. The date and time can also be set when the camera is in the shooting mode.

• Press to display the top menu.

• Press to select MODE MENU.

• Press to select SETUP, and then press .

• Press to select , and then press .

• Use to select the date format.

• Adjust the date and time in the appropriate fields by using to select the field, and to set the proper value.

Repeat this step until all date/time fields have been set.

Note: Time is entered using the 24-hour format.

• Press to store the date and time.

Camera Diagram and Controls

Now take a moment to familiarize yourself with the key areas of camera controls by reviewing the illustrations.

Power on

Power off

TIP

VIDEO OUT

jack

Card cover catch

Self-timer/

Remote control lamp

Flash

Remote control

receiver

USB

connector

Connector

cover

Lens barrier

Lens

DC-IN jack

cover

Card cover

VT420103 Printed in China

UNPACKING THE BOX CONTENTS

Gather your Digital Camera and the parts as shown in the illustration. You’ll need these to complete the steps for the camera

set-up procedures that follow.

START HERE

It is strongly recommended that you follow these step-

by-step numbered instructions to set up and quickly

begin using your new Digital Camera.

OLYMPUS AMERICA INC.

Two Corporate Center Drive, Melville,

NY 11747-3157, U.S.A.

http://www.olympusamerica.com/support

For more detailed instructions on advanced features, please refer to

the printed Basic Manual included in your package, or the Reference

Manual on the CD-ROM.

Camera Settings in Shooting Mode as shown in Monitor

Camera Settings in Playback Mode as shown in Monitor

Note: Depending on the camera settings, not all indicators will be displayed.

Viewfinder

Green lamp

Orange lamp

Monitor button (QUICK VIEW )

Monitor

OK/Menu button

Tripod socket

Shutter button Zoom button

Strap eyelet

Battery

component

cover

Arrow pad ( )

Shooting mode button

Self-timer button

Macro button Flash mode button

Battery check

Green lamp

Flash stand-by

Flash mode

Macro mode

Memory gauge

Shooting mode

Exposure compensation

Self-timer/Remote control

White balance

Metering

Record mode

Number of storable

still pictures

AF target mark

Sequential shooting

Resolution

Battery check

Print reservation

Number of prints

Protect

Record mode

Resolution

Exposure compensation

White balance

Date and time

File number

(still picture)

Olympus Europa GmbH

Wendenstrasse 14-18,

20097 Hamburg, Germany

http://www.olympus-europa.com

The following items are also included in the Digital Camera package: Basic Manual, video cable, RM-2 remote control, warranty card,

registration card (not provided in some areas), and safety precautions booklet.

Digital Camera Strap LI-10B lithium

ion battery

LI-10C

battery

charger

Battery

charger

AC cable

CAMEDIA Master

CD-ROM

USB cable

(gray color)

xD-Picture Card

http://www.olympus.com/

x106_x122qsge_pquick_6.fm Page 1 Thursday, November 6, 2003 10:48 AM

1 2

Summary of Contents

Page 1 - START HERE

QuickStart GuidePREPARING THE CAMERA FOR USEBefore you begin using your Olympus Digital Camera…a.Charging the batteryThe Digital Camera uses

Page 2 - Icon Flash Mode Description

VIEWING AND ERASING PICTURESWith a Digital Camera, you can easily view the photos you want—and delete the ones you don’t.a.Viewing PicturesT

Olympus P-400 User Manual Page 1

Browse online or download User Manual for Photo printers Olympus P-400. Olympus P-400 User Manual

Summary of Contents

More documents for Photo printers Olympus P-400

Comments to this Manuals

Olympus P-400 User Manual Page 1

Browse online or download User Manual for Photo printers Olympus P-400. Olympus P-400 User Manual

Summary of Contents

More documents for Photo printers Olympus P-400

Comments to this Manuals

Related products and manuals for Photo printers Olympus P-400