Olympus PT-019 User Manual download pdf (Page 28)

E-27

Install the O-ring.

Confirm that no foreign matter is attached, apply a thin coat of the

accessory grease to the O-ring, and fit the O-ring into the groove. At

this time, confirm that the O-ring does not stick out from the groove.

: • When a mechanical pencil or a similar other sharp

object is used to remove the O-ring or to clean the

inside of the O-ring groove, the Case and the O-ring

may be damaged and water leakage may be caused.

• When the O-ring is checked with the fingertips, take

care not to stretch the O-ring.

• Never use alcohol, thinner, benzene or similar solvents

or chemicals detergents to clean the O-ring. When such

chemicals are used, it is likely that the O-ring will be

damaged or that its deterioration will be accelerated.

CAUTION

How to Apply Grease to the O-ring

Apply the

specified grease

Make sure there is no dirt on your

fingers or on the O-ring; then

squeeze about 5 mm of grease

onto your fingertip.

Spread the grease

over the O-ring.

Using two fingers and a thumb,

spread the grease over the O-ring

while rubbing it in. Use caution not to

squeeze or pull the O-ring too hard.

Check that there

is no damage or

irregularities on

the O-ring.

Once the grease has permeated

throughout the O-ring, check it for damage

or irregularities (both visually and by

touch). If you notice any abnormalities,

replace the O-ring with a new one.

Apply the grease

to the O-ring

contact surface.

Use any residual grease on your

fingertips to clean and lubricate the O-

ring contact surface on the front lid.

PT_019_en.qxd 2003.9.19 2:13 PM ページ E-27 (1,1)

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 37 38

Comments to this Manuals

No comments

Olympus PT-019 User Manual Page 28

Comments to this Manuals

Related products and manuals for Camera accessories Olympus PT-019