Olympus E-PL2 User Manual Page 89

  • Download
  • Add to my manuals
  • Print
  • Page
    / 124
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 88
89
EN
Customizing camera settings
10
Wireless remote control ash photography
External ash units that offer a remote control mode and are designated for use
with this camera can be used for wireless ash photography. The built-in ash
can independently control up to three groups of remote ash units. See the
documentation provided with the external ash units for details.
1
Set the remote ash units to RC mode and place them as desired.
Turn each ash unit on, press the MODE button, and select RC mode.
Select a channel and group for each ash unit.
2
Select [ON] for [# RC MODE] in X Shooting menu 2 (P. 108).
The super control panel switches to RC mode.
You can choose a super control panel display by repeatedly pressing the INFO
button.
Select a ash mode (note that red-eye reduction is not available in RC mode).
3
Adjust the settings for each group in the super control panel.
Flash intensity value
250250 F5.6
3838
A MODE
TTL
+
1.0
M 1 / 8 LO
OFF
2CH
0.00.0
Group
Select the ash control
mode and adjust the ash
intensity individually for
groups A, B, and C. For
MANUAL, select the ash
intensity.
Normal ash/Super FP ash
Switch between normal
ash and Super FP ash.
Communication light level
Set the communication light
level to [HI], [MID], or [LO].
Channel
Set the communication
channel to the same
channel used on the ash.
Flash
intensity
Flash control
mode
4
Press the #UP button to raise the built-in ash.
After con rming that the built-in and remote ash units have charged, take a
test shot.
Wireless ash control range
Position the wireless ash units with their
remote sensors facing the camera. The
following illustration shows the approximate
ranges at which the ash units can be
positioned. The actual control range varies
with local conditions.
5m
10m
100°100°
50
°50°
50
°50°
60
°60°
30
°
30°
30
°
30°
# Caution
The built-in ash can not be used as a light source in RC mode.
We recommend using a single group of up to three remote ash units.
Remote ash units can not be used for second curtain slow synchronization or anti-
shock exposures longer than 4 seconds.
If the subject is too close to the camera, the control ashes emitted by the built-in
ash may affect exposure (this effect can be reduced by reducing the output of the
built-in ash by, for example, using a diffuser).
Page view 88
1 2 ... 84 85 86 87 88 89 90 91 92 93 94 ... 123 124

Comments to this Manuals

No comments