Olympus PT-15 User Manual download pdf (Page 21)

E-20

Installation Removal

Installation and Removal of the LCD Hood

Installation

Strongly push the mounting projections of the LCD hood as shown in the

figure into the guides above and below the LCD monitor window.

Removal

Remove the mounting projections of the LCD hood from the guides

above and below the LCD monitor window by widening the LCD hood.

: •

After loading the camera into the Case, confirm that the mode

dial moves. If it does not move, there is the possibility that oil or

fat has been attached to the mode dial. Please wipe it clean.

•

When no operation is performed for three minutes after the digital

camera has been loaded (or for the specified time when a different

time has been specified), the camera enters into sleep mode

(standby status) to save battery power. It returns to operation

status when the shutter button or the zoom lever is operated.

CAUTION

Try to move the mode dial.

After sealing, turn the mode dial knob and confirm that the mode dial of the

camera is switched.

Set the power to 'ON'.

Move the power switch lever and confirm that the camera power can be

switched ON and OFF.

Perform the final checks.

Visual Inspection

After sealing the Case, check the sealing part of front and rear lid visually

to confirm that the O-ring is not twisted or out of the groove and that no

foreign matter has been caught.

: •

Hairs, fibers, and other narrow items are not very apparent, but

they may cause entry of water, so that special attention is required.

CAUTION

PT-015_英 2003.5.1 4:37 PM ページ 21 (1,1)

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 38 39

No comments

Olympus PT-15 User Manual Page 21