Olympus PT-E05 User Manual download pdf (Page 74)

EN 33

Install the O-ring

Confirm that no foreign matter is attached, apply a thin coat of the accessory grease to the O-ring, and

fit the O-ring into the groove. At this time, confirm that the O-ring does not stick out from the groove.

How to Apply Grease to the O-ring

1 Apply only Olympus

exclusive lubricant to each

O-ring.

Make sure that your fingers and the O-ring are

free of dirt, and squeeze about 5 mm of

lubricant onto a finger. (5 mm is the most

appropriate amount.)

2 Spread the lubricant onto

the entire circumference of

the O-ring.

Spread the grease onto the entire

circumference of the O-ring using 3 fingers.

Be careful not to use excessive force as this

may stretch the O-ring.

3 Check that the O-ring is free

of scratches or unevenness.

After spreading the lubricant, check visually

and by touch that the O-ring is not scratched

and that its surface is flat. If it is damaged in

any way, replace it with a brand-new O-ring.

4 Apply lubricant on the O-ring

contact surface.

Use the lubricant remaining on the fingers to

clean and lubricate the case’s contact surface.

CAUTION:

• Always perform maintenance of the waterproof function even when the Case has been opened to exchange

the battery or the image storage during shooting. Neglecting this maintenance may become the cause of

water leakage.

• When the Case is not to be used for a long time, remove the O-ring from the groove to prevent deformation

of the O-ring, apply a thin coat of silicone grease, and store it in a clean plastic bag or the like.

• Drying the Case with adhering salt may impair the function. Always wash off any salt after use.

PT-E05_EN.Book Page 33 Tuesday, June 17, 2008 11:11 AM

1 2 ... 69 70 71 72 73 74 75 76 77 78 79 ... 283 284

No comments

Olympus PT-E05 User Manual Page 74