28 En
En
J USING THE FLASH
1
Push the flash lever up.
• The flash pops up.
2
Set the flash mode by repeatedly pressing #.
• The flash mode changes in the sequence shown below (when all
modes are available).
• To prevent the flash from firing, press down on the top of the flash to
retract it.
3
Press the shutter button halfway.
• In conditions where the flash will fire, # lights.
4
Press the shutter button fully to take the picture.
TIPS
Flash working range
W (max.): Approx. 0.3 m – 4.5 m (1.0 ft. – 14.8 ft.)
T (max.) : Approx. 1.2 m – 3.5 m (3.9 ft. – 11.5 ft.)
Auto-flash (No indication)
The flash fires automatically in low light or backlight conditions.
Red-eye reduction flash (!
!!
!)
The red-eye reduction flash mode reduces the red-eye phenomenon by
emitting pre-flashes before firing the regular flash.
Fill-in flash (#
##
#)
The flash always fires every time the shutter button is pressed.
Flash off ($
$$
$)
The flash does not fire even in low light conditions.
Slow synchronization #
##
#SLOW1 #
##
#SLOW2 !#
!#!#
!#SLOW1
1st curtain (front curtain) #
##
#SLOW1 (factory default setting):
Adjusts the flash for slow shutter speeds.
2nd curtain (rear curtain) #
##
#SLOW2:
The 2nd curtain fires the flash just before the shutter closes.
No indication
(Auto-flash)
#Slow (Slow
synchronization)
(Red-eye
reduction flash)
#(Fill-in flash)
basic_e_po167_6.fm Page 28 Tuesday, February 4, 2003 5:06 PM
Comments to this Manuals