For the digital cameraCAMEDIA C-760 Ultra Zoom/C-770 Ultra Zoom Thank you for buying the Underwater Case PT-022. Please read this instruction manual
E-91. PreparationsCheck the contents of the package.Check that all accessories are in the box.Contact your dealer if accessories should be missing or
E-10Names of the partsNote :The Case operation parts marked by❈ corresponds to the operation partsof the digital camera. When the operation parts of t
E-11Install the strap.Install the strap on the Case body.:Please install the strap correctly as shown above. OLYMPUSCORPORATION shall bear no responsi
E-12How to Press the ShutterWhen pressing the shutterlever, press it gently, so thatthere will be no movement ofthe camera.Note: • For detailed operat
E-13Setting the Zoom LeverWhen loading the digitalcamera in the Case, fit theprojecting part of the zoomlever of the digital camera intothe recessed p
E-14Note: •When the set time (initial setting: 3 minutes) passes without anyoperation while the digital camera is installed in shooting mode,the camer
E-15Note: • For details about using the flash for taking pictures, refer tothe instruction manual for the camera.Flash operation procedurePress the fl
E-16Removing the TLL cable connector capTTL flash shooting by combining this case (PT-022) and the case forFL-20 flash (optional PFL-01):TTL cable con
E-17Removing the hot shoe cable capTo perform TTL flash shooting when this case is used, connect thehot shoe cable provided with the optional PFL-01 b
E-182. Advance Check of the CaseAdvance test before useThis Case has been the subject of thorough quality control for the partsduring the manufacturin
E-1Introduction● Unauthorized copying of this manual in part or in full, except forprivate use, is prohibited. Unauthorized reproduction is strictly p
E-193. Install the digital camera.Check the digital camera.Check the digital camera before loading it in the Case.Battery ConfirmationAs the LCD monit
E-20Check the operation of the camera.Confirm the operation according to the instruction manual for the digital camera.Load the digital camera.Open th
E-21Insertion of silica gelPay attention to the orientation.Before sealing the Case, insert the accessory silica gel bag forprevention of fogging betw
E-22Install the special balance weight.Seal the Case.Check the loading status.: • Seal the Case by turning both buckle lock leversdown in arrow direct
E-23Installation and Removal of the LCD HoodInstallationStrongly push the mounting projections of the LCD hood as shownin the figure into the guides a
E-24Perform the final checks.Visual InspectionAfter sealing the Case, check the sealing part of front and rear lidvisually to confirm that the O-ring
E-25Now everything is all right!Have a nice dive!Did you remember to attach thebalance weight?Final TestThe final test after loading the camera is exp
E-264. Taking Pictures Under WaterHow to Use the Hand StrapPass your hand through the accessory hand strap and adjust thelength with the stop button.T
E-275. Handling After ShootingWipe off any waterdrop.After completing the shootingand returning to land, wipe offany waterdrop sticking to theCase. Us
E-28Take out the digital camera.Open the case carefully, pull up the mode dial from the upper surface ofthe case to disengage it from the mode lever o
E-21. Keep this product out of the reach of babies, infants, and children.There is the possibility of occurrence of the following types ofaccidents.
E-29Wash the Case with pure water.After use, seal the Case again after taking out the camera and wash itsufficiently in pure water as soon as possible
E-306. Maintaining the Waterproof FunctionRemove the O-ring.Open the Case and remove the O-ring from the Case.Removal of the O-ring Insert the O-ring
E-31: • When a mechanical pencil or a similar other sharp objectis used to remove the O-ring or to clean the inside of theO-ring groove, the Case and
E-321Install the O-ring.Confirm that no foreign matter is attached, apply a thin coat of theaccessory grease to the O-ring, and fit the O-ring into th
E-33Clean and apply O-ring silicon grease to these sections.Maintenance of the threaded sections on the TTL cable and TTL cable connectorIf the thread
E-34Replace consumable products. The O-ring is a consumable product. Independent of the number oftimes the Case is used, it is recommended that the O
E-357. AppendixQ & A on the use of the PT-022Q1 : Which digital cameras can be used?A1 : The PT-022 is only for the models C-760 Ultra Zoom/C-770
E-36(3) In case of the following handling with a camera loaded into the Case,trouble or breakage may be caused for the Case and/or the loadedcamera. A
E-37dry them. When an object with a sharp tip is used to remove the O-ringfrom the groove, the O-ring may be damaged and water leakage may becaused. A
E-38Q9 : What are the important points for O-ring maintenance?A9 : Please observe the following items.(1) Never use alcohol, thinner, benzene or simil
E-3Batteries● Always use lithium ion battery packs manufactured by Olympusand bearing the Olympus brand. For more details, refer to yourcamera's
E-39Q11:Please tell me about repairs.A11:Please contact a service station of OLYMPUS CORPORATION or yourdealer, if repair should be necessary. Do not
E-40After-sale Service● You will receive the guarantee card from your dealer. Please makesure that the dealer's name, the date of purchase, etc.
E-41Specifications❈ We reserve the right to change the external appearance and thespecifications without notice.Available modelsOlympus digital camera
E-42MEMOPT_022_E.qxd 2004.3.18 4:34 PM ページE-42
When water leakage occurs while this product is being used, repair of thecamera housed in this product may become impossible. Please observethe follow
E-5Handling the Product● Use or storage of the product at the following locations may causedefective operation, defects, trouble, damage, fire, intern
E-6● Do not perform operations other than specified in this instructionmanual, do not remove or modify parts other than specified, and donot use parts
E-7Introduction ......E-1Please read the following items before use ...
E-8Check the loading status. ..............E-22Seal the Case. ............
Comments to this Manuals