Olympus UFL-2 User Manual download pdf (Page 18)

EN 18

3. Inserting the Batteries

Usable batteries (sold separately)

Always use one of the following battery combinations:

AA alkaline batteries/AA NiMH batteries/AA lithium batteries/

AA oxyride batteries/AA NiCd batteries

• Manganese batteries are not to be used.

Inserting the batteries

1 Carefully rotate the battery cap counterclockwise to remove it.

2 Install the batteries in the correct manner paying especial attention to match

the (+) and (-) marks.

3 Make sure to check that there is no foreign matter, rubbish etc. not only on

the O-ring but also on the contact surface (battery cap side).

4 Thinly apply the specified silicone O-ring grease to the O-ring.

5 Match the O mark on the battery cap (back side) with the O mark on the

flash and while pushing the battery cap, turn gently in a clockwise direction

until it can’t turn anymore.

• While putting the cap back on take special care so that the O-ring

does not project from the groove.

After replacing the battery cap tightly, turn it back slightly in a counterclockwise

direction and align the marks.

• After aligning the marks, make sure no O-ring can be seen.

O Mark

Alignment marks

O-ring

Correct

(The O-ring can’t be seen)

Incorrect

(The O-ring can be seen)

12 45

r2090_e_00.book Page 18 Thursday, May 1, 2008 6:29 PM

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 40 41

No comments

Olympus UFL-2 User Manual Page 18