Olympus UFL-2 User Manual download pdf (Page 8)

EN 8

About O-ring

Please note the following points to use the O-ring.

z When sealing this product, make sure that no hairs, fibers, sand

particles or other foreign matter stick not only to the O-ring, but also to

the contact surface. Even a single hair or a single grain of sand may

cause water leakage. Please check with special care.

z The O-ring is a consumption product. Please replace it at least once a

year with a new one. Also perform maintenance with every use.

z Deterioration of the O-ring will progress according to the conditions of

use and the storage conditions. Immediately replace the O-ring with a

new one if it is damaged, shows cracks, or has lost its elasticity.

z At the time of O-ring maintenance, clean the inside of the O-ring groove

and confirm the absence of dirt, dust, sand, and other foreign matter.

z Apply the specified silicone O-ring grease to the O-ring.

z The waterproof function is not effective when the O-ring is not installed

correctly. When installing the O-ring, take care that it does not project

from the groove and that it is not twisted. Also, when installing the

battery cap, close it after confirming that the O-ring has not come out of

the groove.

Handling the product

z Use or storage of the product at the following locations may cause

defective operation, defects, trouble, damage, a fire, internal clouding,

or water leakage. Always avoid these locations:

• Place in direct sunlight such as in a closed vehicle.

Examples of foreign matter sticking to the O-ring

Hair Fibers Grains of sand

r2090_e_00.book Page 8 Thursday, May 1, 2008 6:29 PM

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 40 41

No comments

Olympus UFL-2 User Manual Page 8