EN 24
EN
Shooting
When the flash is connected using the underwater fiber optic
cable
Following is an explanation of the basic method for taking pictures with the
flash connected to a camera’s underwater case using the underwater fiber
optic cable. Refer to your camera’s instruction manual for details about the
camera’s operation.
1 Press the MODE button on the flash repeatedly to set the flash to RC mode.
2 Set the camera’s RC mode to ON and set the camera’s built-in flash so as
to allow it to be emitted.
• Set the flash mode and the flash intensity on the camera.
3 While holding the MODE button pressed down, turn the dial to select the
channel and group.
Channel : Set the same channel, between 1 and 4, on the camera
and flash.
Group : You can control up to 3 groups (A, B and C) of flash arrays
with different flash modes and other settings. On the
electronic flash set in advance the group with which the
flash will be emitted.
4 Press the ZOOM button to adjust the firing angle.
5 After the shooting preparations are completed, take some test shots to
check the flash operation and the resulting images.
Channel
RC mode
Group
MODE button
r2090_e_00.book Page 24 Thursday, May 1, 2008 6:29 PM
Comments to this Manuals