Olympus CAMEDIA E-10 User Manual download pdf (Page 11)

English

CR-V3

AA (R6) Ni-MH,

Ni-Cd or Alkaline

Attaching the Strap

Slide one end of the strap through a strap

eyelet on the camera. Slide the end of the strap

through the sleeve and frame on the strap, and

then slide the sleeve completely up to the

eyelet. Pull the strap tight around the frame and

make sure that it does not slip. In the same

way, attach the other end of the strap to the

eyelet on the other side of the camera.

Inserting the batteries

You can use 2 lithium battery pack (CR-V3), or

4 AA (R6) Ni-MH, Ni-Cd or Alkaline batteries

with this camera. Make sure the power switch is

at the OFF position. Confirm that the card

access lamp is off. Raise the battery

compartment knob and turn it to the open

position . Remove the battery holder.

If you are inserting lithium batteries, install a set

in each side of the battery holder. If you are

installing AA (R6) batteries, install 2 batteries in

each side of the holder. Make sure that you do

not reverse the polarities of the batteries when

you insert them. Gently press down on the

batteries until they lock in place. Insert the

battery holder into the bottom of the camera.

While pushing down on the battery holder, turn

the battery compartment knob to the close

position .

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 117 118

No comments

Olympus CAMEDIA E-10 User Manual Page 11