Olympus CAMEDIA E-20 User Manual download pdf (Page 12)

ISO Max. WIDE (WIDE Limit) Max. TELE (TELE Limit)

AUTO 0.6 - 8.9 m 0.5 - 7.4 m

80 0.6 - 6.3 m 0.5 - 5.2 m

160 0.9 - 8.9 m 0.7 - 7.4 m

320 1.3 - 12.5 m 1.0 - 10.4 m

Using the Zoom and Macro Functions

To zoom in and make the subject larger in the

viewfinder, rotate the zoom ring to the left. To

zoom out and make the subject smaller, rotate

the zoom ring to the right. You can take a

picture up to 0.6 m from the subject.

You can also take very close shots within a

range of 0.2 m to 0.6 m from the subject by

setting the camera in the macro mode. To set

the camera in the macro mode, hold down the

macro button and then turn the main dial or

sub dial until you see the macro mark in the

control panel. Repeat the procedure to switch

off the macro mark and return the camera to

normal operation.

Using the Built-in Flash

When the flash warning blinks in the lower left corner of the viewfinder, there is not enough light to

take the picture. Press the flash button to raise the built-in flash unit, and then take the picture.

After raising the flash, the flash warning may continue to blink until the flash is fully charged. When

you take the picture, the flash will fire with an intensity adjusted automatically for the best exposure.

Flash Range

Use the flash within these ranges to prevent overexposure and underexposure of your pictures.

Rapidly firing the flash could cause it to overheat. Do not fire it more than 30 times in succession.

After prolonged use, allow the flash to cool for at least 10 minutes between shooting sessions. Before

using the flash, make sure that its face is clean.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 115 116

No comments

Olympus CAMEDIA E-20 User Manual Page 12