Olympus PT-022 User Manual download pdf (Page 25)

E-24

Perform the final checks.

Visual Inspection

After sealing the Case, check the sealing part of front and rear lid

visually to confirm that the O-ring is not twisted or out of the groove

and that no foreign matter has been caught.

Fit the lens cap onto the lens

ring as shown in the figure. Be

sure to remove the lens cap

before shooting.

Mounting and Removing the Lens Cap

: • After loading the camera into the Case, confirm that the

mode dial moves. If it does not move, there is the

possibility that oil or fat has been attached to the mode

dial. Please wipe it clean.

CAUTION

Try to move the mode dial.

After sealing, turn the mode dial knob and confirm that the mode

dial of the camera is switched.

Set the power to 'ON'.

Move the power switch and confirm that the camera power can be

switched ON and OFF.

: • Hairs, fibers, and other narrow items are not very apparent,

but they may cause entry of water, so that special attention

is required.

CAUTION

PT_022_E.qxd 2004.3.18 4:34 PM ページE-24

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 42 43

No comments

Olympus PT-022 User Manual Page 25