For the digital cameraCAMEDIA X-3 Thank you for buying the Underwater Case PT-024. Please read this instruction manual carefully and use the product
E-91. PreparationsCheck the contents of the package.Check that all accessories are in the box.Contact your dealer if accessories should be missing or
E-10Names of the partsNote :The Case operation parts marked by❈corresponds to the operation partsof the digital camera. When the operation parts of th
E-11Install the strap.Install the strap on the Case body.:Please install the strap correctly as shown above. OLYMPUSCORPORATION shall bear no responsi
E-12How to Press the ShutterWhen pressing the shutterlever, press it gently, so thatthere will be no movement ofthe camera.Note: • For detailed operat
E-132. Advance Check of the CaseAdvance test before useThis Case has been the subject of thorough quality control for theparts during the manufacturin
E-143. Install the digital camera.Check the digital camera.Check the digital camera before loading it in the Case.Battery ConfirmationAs the LCD monit
E-15Loading in the CaseWhich digital cameras can be loaded?This product (PT-024) is exclusively used for the CAMEDIA X-3.Open the lens barrier.When th
E-16Load the digital camera.Quietly load the digital camera into the Case, taking care that theprojecting part of the zoom lever of the digital camera
E-17Insertion of silica gelBefore sealing the Case, insert the accessory silica gel bag forprevention of fogging between the bottom of the camera and
E-18Seal the Case.Check the loading status.:•Seal the Case by turning both buckle lock levers downin arrow direction. When one of the buckles is lefto
E-1Introduction● Unauthorized copying of this manual in part or in full, except forprivate use, is prohibited. Unauthorized reproduction is strictly p
E-19Installation and Removal of the LCD HoodInstallationStrongly push the mounting projections of the LCD hood as shownin the figure into the guides a
E-20Perform the final checks.Visual InspectionAfter sealing the Case, check the sealing part of front and rear lidvisually to confirm that the O-ring
E-21Now everything is all right!Have a nice dive!Final TestThe final test after loading the camera is explained below. This is the only way toeliminat
E-224. Taking Pictures Under WaterHow to Use the Hand StrapPass your hand through the accessory hand strap and adjust thelength with the stop button.T
E-235. Handling After ShootingWipe off any waterdrop.After completing the shootingand returning to land, wipe offany waterdrop sticking to theCase. Us
E-24Take out the digital camera.Open the case carefully, pull up the mode dial from the upper surface ofthe case to disengage it from the mode lever o
E-25Wash the Case with pure water.After use, seal the Case again after taking out the camera and wash itsufficiently in pure water as soon as possible
E-266. Maintaining the Waterproof FunctionRemove the O-ring.Open the Case and remove the O-ring from the Case.Removal of the O-ring Insert the O-ring
E-27:•When a mechanical pencil or a similar other sharp objectis used to remove the O-ring or to clean the inside of theO-ring groove, the Case and th
E-281Install the O-ring.Confirm that no foreign matter is attached, apply a thin coat of theaccessory grease to the O-ring, and fit the O-ring into th
E-21. Keep this product out of the reach of babies, infants, and children.There is the possibility of occurrence of the following types ofaccidents.
E-29Replace consumable products. The O-ring is a consumable product. Independent of the number oftimes the Case is used, it is recommended that the O
E-307. AppendixQ & A on the use of the PT-024Q1 :Which digital cameras can be used?A1 :The The PT-024 is only for the models X-3.Q2 :What cautions
E-31(3)In case of the following handling with a camera loaded into theCase, trouble or breakage may be caused for the Case and/orthe loaded camera. Al
E-32of the Case and deterioration of the O-ring. Wipe the inside of the Casewith a soft cloth not causing any fibers. Remove the O-ring, wipe off anys
E-33(7)Throwing the Case from a boat into the water, jumping with the Caseinto the water, or other sudden application of strong forces onto theCase. W
E-34Olympus defogging silica gel.•Do not use adhesive for repairs or other purposes. When repair isrequired, please contact a service station of our c
E-35After-sale Service● You will receive the guarantee card from your dealer. Please makesure that the dealer's name, the date of purchase, etc.
E-36Specifications❈ We reserve the right to change the external appearance and thespecifications without notice.Available modelsOlympus digital camera
E-3Batteries● Please use one Olympus lithium ion rechargeable battery forcameras (LI-12B).● Take care that the battery electrodes do not become wet. T
When water leakage occurs while this product is being used, repair of thecamera housed in this product may become impossible. Please observethe follow
E-5Handling the Product● Use or storage of the product at the following locations may causedefective operation, defects, trouble, damage, fire, intern
E-6● Do not perform operations other than specified in this instructionmanual, do not remove or modify parts other than specified, and donot use parts
E-7Introduction ......E-1Please read the following items before use ...
E-8Check the loading status. ..............E-18Seal the Case. ............
Comments to this Manuals