Olympus PPO-E04 User Manual download pdf (Page 16)

E-4

3 Attaching/Removing the Front Cap

To attach the front cap, fit it into the front end (lens hood) of the PPO-E04 as shown below. The front cap

can be removed by reversing the attaching procedure. Be sure to remove the front cap before shooting.

CAUTION: Make sure that the PPO-E04 is completely dry before attaching or removing the front cap.

4 Adjusting the Lens Hood Position

If the corners of the image in the pickup finder are cut off after the PPO-E04 is attached, adjust the lens

hood position.



Using the clamping screw securing wrench provided with the PPO-E04, loosen the four lens hood clamping

screws on the PPO-E04.



Adjust the hood until the image in the pickup finder is not cut off.



Set the lens hood to the position where the image is not cut off.



Tighten the lens hood clamping screws to clamp the lens hood in that position.

Tu rn the lens hood to

adjust the position.

Tighten screws to clamp

the lens hood.

 





1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 79 80

No comments

Olympus PPO-E04 User Manual Page 16