Olympus PT-E05 User Manual download pdf (Page 22)

EN 21

Insert the digital camera in the Case.

Load the digital camera in the Case after checking the following:

• Is the digital camera turned OFF?

• Is a medium loaded in the digital camera?

• Is the battery fully charged?

• The strap, lens cap and filter are removed from the digital camera.

• The camera table provided with the Case is attached to the tripod screw hole at the bottom of the digital

camera.

• The camera’s eyecup is removed from the camera’s viewfinder.

• The zoom gear and focus gear are attached to the camera’s lens.

1 Pull out the zoom dial and mode dial on the Case (pulling out the mode dial also pulls up the power

switch lever) so that they do not get in the way while loading the digital camera.

At this time, set the orientation of the power switch lever as shown below.

2 When using an electronic flash with a TTL cable, remove the TTL cable connector cap on the hot

shoe connector, which is located in the top left corner of the inner side of the front lid. and connect

the TTL cable to the connector.

CAUTION:

When screwing in the hot shoe connector clamping screw, place the Case upside down. Be careful not to

drop the Case.

(Power switch lever)

Set the orientation to 10 o’clock.

Remove the cap by turning it

counterclockwise.

PT-E05_EN.Book Page 21 Wednesday, June 4, 2008 12:34 PM

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 41 42

No comments

Olympus PT-E05 User Manual Page 22