Olympus PT-E05 User Manual download pdf (Page 33)

EN 32

6. Maintaining the Waterproof Function

Remove the O-ring.

Open the Case and remove the O-ring.

Procedure

1 Insert the O-ring remover into the gap between the O-ring and O-ring groove wall.

2 Bring the tip of the inserted O-ring remover below the O-ring. (Be careful not to damage the groove

with the tip of the O-ring remover.)

3 Lift the O-ring, pinch it with your fingertips and pull it out of the Case.

Remove any sand, dirt, etc.

After visually checking that dirt has been removed

from the O-ring, check for attached sand and other

foreign matter, as well as for damage and cracks

by squeezing the entire circumference of the O-

ring lightly with your fingertips.

Remove attached foreign matter from the O-ring

groove with a clean cloth or a cotton swab. Also

remove any sand or dirt attached to any part of the

Case that comes into contact with the O-ring.

CAUTION:

• When a mechanical pencil or any other sharp object is used to remove the O-ring or to clean the inside of

the O-ring groove, the Case and the O-ring may be damaged and water leakage may be caused.

• When the O-ring is checked with the fingertips, take care not to stretch the O-ring.

• Never use alcohol, thinner, benzene or similar solvents or chemicals detergents to clean the O-ring. When

such chemicals are used, it is likely that the O-ring will be damaged or that its deterioration will be

accelerated.

PT-E05_EN.Book Page 32 Wednesday, June 4, 2008 12:34 PM

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 41 42

No comments

Olympus PT-E05 User Manual Page 33