Olympus E-520 User Manual Page 108

  • Download
  • Add to my manuals
  • Print
  • Page
    / 147
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 107
Shooting tips and maintenance
12
12
108
EN
Shooting tips and maintenance
Tips before you start taking pictures
The camera does not turn on even when a battery is loaded
The battery is not fully charged
Charge the battery with the charger.
The battery is temporarily unable to function because of the cold
Battery performance declines in low temperatures, and the charge may not be sufficient to turn on the
camera. Remove the battery and warm it by putting it in your pocket for a while.
No picture is taken when the shutter button is pressed
The camera has turned off automatically
To save battery power, if there is no operation, the camera goes into sleep mode after a fixed period
of time and the camera stops operating. The camera activates again when you touch the shutter
button or any other button. The camera will turn off automatically if there is no further operation for 4
hours. The camera will not work until it is turned back on.
g
“SLEEP” (P. 91), “4 h TIMER (Auto
power off)” (P. 91)
The flash is charging
When the flash is raised, the
#
symbol blinking in the super control panel or the viewfinder indicates
that the flash is charging. Wait for the blinking to stop, then press the shutter button.
Unable to focus
When the AF confirmation mark in the viewfinder is blinking, it indicates that the camera is unable to
focus using AF. Press the shutter button again.
Noise reduction is activated
When shooting night scenes, shutter speeds are slower and noise tends to appear in images. The
camera activates the noise-reduction process after shooting at slow shutter speeds. During which,
shooting is not allowed. You can set
[NOISE REDUCT.]
to
[OFF]
.
g
“Noise reduction” (P. 67)
The date and time has not been set
The camera is used with the settings at the time of purchase
The date and time of the camera is not set when purchased. Set the date and time before using the
camera.
g
“Setting the date / time” (P. 15)
The battery has been removed from the camera
The date and time settings will be returned to the factory default settings if the camera is left without
the battery for approximately 1 day. The settings will be canceled more quickly if the battery was only
loaded in the camera for a short time before being removed. Before taking important pictures, check
that the date and time settings are correct.
Shooting tips and information
Page view 107
1 2 ... 103 104 105 106 107 108 109 110 111 112 113 ... 146 147

Comments to this Manuals

No comments