Olympus SP-610UZ User Manual Page 37

  • Download
  • Add to my manuals
  • Print
  • Page
    / 84
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 36
37
EN
Selecting the ISO sensitivity
1
Select the ISO setting option in the function
menu.
PP
0.00.0
AUTO
WB
AUTO
WB
200
ISO
200
ISO
100
ISOISO
100
1/400 F3.3F3.31/400
400
ISO
400
ISO
ISO 200ISO 200
MENUMENU
2
Use HI to select the setting option, and
press the A button to set.
Option Description
ISO Auto
The camera automatically adjusts
the sensitivity according to the
shooting scene.
High ISO Auto
The camera uses a higher sensitivity
compared to [ISO Auto] to minimize
blur caused by a moving subject or
by camera shake.
Value
The ISO sensitivity is xed to the
selected value.
In the ISO setting, although smaller values result in
less sensitivity, sharp images can be taken under fully
lit conditions. Larger values result in higher sensitivity,
and images can be taken at fast shutter speeds even
under low light conditions. However, high sensitivity
introduces noise into the resulting picture, which may
give it a grainy appearance.
Sequential shooting (Drive)
Pictures are taken sequentially while the shutter button
is held down.
1
Select the drive option in the function menu.
0.00.0
AUTO
WB
AUTO
WB
AUTO
ISO
AUTO
ISO
PP
SequentialSequential
MENUMENU
14
M
44
N
ORM
Option Description
o
One frame is shot each time the
shutter button is pressed.
j
*1
Take sequential shots using the
focus, brightness (exposure) and
white balance set in the rst frame.
c
The camera takes sequential shots
at a faster speed than in [j].
d
The camera takes sequential shots
at approximately 10 frames/sec.
*1
The shooting speed varies depending on the settings
for [Image Size/Compression] (p. 39).
When set to [j], the ash (p. 34) cannot be set to
[Redeye]. In addition, when set to [c] or [d], the
ash is xed to [Flash Off].
When set to [c] or [d], [Image Size] is limited to
[n] or lower (for [c]), or [3] or lower (for [d]),
and the ISO sensitivity is xed to [ISO Auto].
When set to [j] , [Image Size] cannot be set
to [6]. Also, when set to [j] and [Image
Size] is [4] or [K], [Fine] cannot be set for
[Compression].
Page view 36
1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 83 84

Comments to this Manuals

No comments