Olympus E-520 User Manual download pdf (Page 114)

114

Shooting tips and maintenance

Taking pictures of a subject against backlight

If the background is too bright compared to the subject, the exposure will be affected at the

bright parts and the subject will appear darker. This is because the camera determines the

exposure from the brightness of the whole screen.

•Set [METERING] to [n] (spot metering) to measure the exposure of the subject in the center of

the picture. To change the composition, place the subject in the center of the picture. While holding

down the AEL/AFL button, change the composition and press the shutter button. g“Changing

the metering mode” (P. 47)

• Activate the flash, set the flash mode to [#] (fill-in flash) and shoot the picture. You can shoot a

subject against backlight without the face of the subject appearing dark. [#] (fill-in flash) is used

for shooting against backlight and under fluorescent and other artificial lighting. g“Flash mode

setting” (P. 70)

Image turns out too bright or too dark

When taking pictures in S mode or A mode, the displayed shutter speed or aperture setting

may blink. A blinking display means that the correct exposure cannot be obtained. If you take

the picture as is, the picture will appear too bright or too dark. If that happens, change the

aperture setting or shutter speed.

g“Aperture priority shooting” (P. 44), “Shutter priority shooting” (P. 44), “Exposure warning

display” (P. 125)

Unknown bright dot(s) appear on the subject in the picture taken

This may be due to stuck pixel(s) on the image pickup device. Perform [PIXEL MAPPING]. If

the problem persists, repeat pixel mapping a few times. g“Pixel mapping k Checking the

image processing functions” (P. 120)

Additional shooting tips and information

Increasing the number of pictures that can be taken

The captured image will be recorded on the card. The following ways describe how to record

more images.

• Change the record mode.

The size of an image varies with the record mode. When you are not sure of the available card

capacity, change the image mode and shoot the picture. The smaller the image size and the

higher the compression, the smaller the size of the image becomes. To make the file size small,

combine the image size and compression rate and register it with [K SET].

You can further reduce the number of pixels by setting [PIXEL COUNT] to fewer pixels for image

size [X] or [W]. g“Selecting the record mode” (P. 62), “K SET” (P. 96), “PIXEL

COUNT” (P. 96)

• Use a card with large capacity.

The number of recordable images varies with the capacity of the card. Use a card with large

capacity.

Using a new card

If you use a non-Olympus card or a card used for another application, such as for a

computer, the message [CARD ERROR] is displayed. To use this card with this camera, use

the [FORMAT] function to format the card. g“Formatting the card” (P. 121)

s0018_e_00_0_unified.book Page 114 Tuesday, March 18, 2008 4:08 PM

1 2 ... 109 110 111 112 113 114 115 116 117 118 119 ... 147 148

Comments to this Manuals

No comments

Olympus E-520 User Manual Page 114

Comments to this Manuals

Related products and manuals for Cameras Olympus E-520