Olympus E-520 User Manual Page 59

  • Download
  • Add to my manuals
  • Print
  • Page
    / 148
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 58
59
EN
5
Focusing and shooting functions
Mount the camera securely on a tripod, point the
remote control at the remote control receiver on the
camera and press the shutter button on the remote
control.
When <0s is selected :
The focus and exposure are locked, the remote
control lamp blinks and the picture is taken.
When <2s is selected :
The focus and exposure are locked, the remote
control lamp blinks, and after approximately 2
seconds the picture is taken.
Transmitted signal effective area
Point the remote control at the remote control receiver of the camera within the effective area
as shown below.
When powerful lighting such as direct sunlight is shining on the remote control receiver, or
when fluorescent light or devices emitting electrical or radio waves are nearby, it could
narrow the effective area.
The remote control lamp does not blink after the shutter button on the remote control
is pressed:
j The transmitted signal may not be effective if the remote control receiver is exposed to powerful
lighting. Move the remote control closer to the camera and press the shutter button on the remote
control again.
j The transmitted signal may not be effective if the remote control is too far from the camera. Move
the remote control closer to the camera and press the shutter button on the remote control again.
j There is signal interference. Change the channel as described in the remote control’s manual.
To cancel the remote control shooting mode:
j The remote control shooting mode will not be canceled after shooting. Press the j/Y/< button
to set to [o] (single-frame shooting), etc.
To use the shutter button on the camera in the remote control shooting mode:
j The shutter button on the camera still works even in the remote control shooting mode.
x Notes
The shutter will not be released if the subject is not in focus.
Under bright light conditions, the remote control lamp may be difficult to see, making it hard to
determine whether or not the picture has been taken.
Zoom is not available on the remote control.
TIPS
Remote control lamp
Remote control receiver
Remote control
Remote control receiver
s0018_e_00_0_unified.book Page 59 Tuesday, March 18, 2008 4:08 PM
Page view 58
1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 147 148

Comments to this Manuals

No comments