Olympus PT-043 User Manual download pdf (Page 54)

EN 16

3. Install the digital camera

Check the digital camera.

Check the digital camera before loading it in the Case.

Battery Confirmation

The flash is used very frequently during underwater shooting.

Make sure that you have enough remaining battery power.

Confirmation of the Remaining Number of Pictures to be Taken

Confirm that the image storage has a sufficient remaining number of

pictures to be taken.

Remove the hand strap from the digital camera.

When a strap is attached to the digital camera, the hand strap must be

removed.

Prepare the camera.

Applicable Digital Cameras

This product (PT-043) is designed exclusively for use with the µ 1030 SW/

Stylus 1030 SW digital camera.

Turn on the digital camera.

To save battery power, the camera automatically goes into sleep mode

and the monitor turns off if there is no operation when the camera is turned

on. No picture is taken even if the shutter lever is fully pressed in this

mode. Operate the zoom buttons or other buttons to restore the camera

from sleep mode before taking a picture. If the camera is left for 15

minutes, it automatically turns off. Press POWER button to turn the

camera on.

Note:

In order to avoid losing shutter chances due to an exhausted battery, you

should always replace a battery with a fully charged battery before each dive.

CAUTION:

• When a digital camera is loaded without removing the strap, the strap may

get caught between the Case lids and may cause water leakage.

• When removing the strap, handle the digital camera with sufficient care.

OLYMPUS IMAGING CORP. shall not be responsible for damage caused

by dropping the camera etc.

PT-043_EN.book Page 16 Friday, December 7, 2007 5:30 PM

1 ... 53 54 55 ... 268

No comments

Olympus PT-043 User Manual Page 54