Olympus PT-043 User Manual download pdf (Page 73)

EN 35

Q5: How should the Case be handled after use?

A5: After use, take out the camera as soon as possible and wash the

Case with pure water. In case of use in the ocean, it is effective to

immerse the Case for a certain time in pure water to remove any

salt. Operate the buttons and levers under water to turn the shafts

and wash off any salt. After washing, use a dry cloth without any

salt on it to wipe off any moisture and dry the Case in the shade.

Do not use hot air from a hair dryer or the like and do not dry the

Case under direct sunlight. Exposure to high temperature or direct

sunlight may cause deformation, discoloration or breakage of the

Case and deterioration of the O-ring. Wipe the inside of the Case

with a soft cloth not causing any fibers. Remove the O-ring, wipe

off any salt, sand, dust, etc., and also clean the O-ring groove and

the O-ring contact surface in the same way and then dry them.

When an object with a sharp tip is used to remove the O-ring from

the groove, the O-ring may be damaged and water leakage may

occur. Always use the O-ring remover provided.

Q6: How should I take pictures under water?

A6: Please observe the following items for shooting under water.

1 Fix the protector with the hand strap provided to your wrist.

2 When you place a finger onto the lens window, the finger will

appear in the photo. Pay attention to the position of your fingers

when holding the Case.

3 Hold the Case securely with both hands and press the shutter

lever gently to prevent camera shake.

4 Check the image you want to shoot by viewing the digital

camera’s LCD monitor through the Case’s LCD monitor

window, and start shooting. In order to avoid losing shutter

chances due to an exhausted battery, you should always

replace a battery with a fully charged battery before each dive.

PT-043_EN.book Page 35 Friday, December 7, 2007 5:30 PM

1 ... 72 73 74 ... 268

No comments

Olympus PT-043 User Manual Page 73