Olympus PT-043 User Manual download pdf (Page 57)

EN 19

Seal the Case.

Check the operation of the loaded camera.

After sealing the Case, check that the camera functions normally.

1 Push the POWER button on the Case and confirm that the camera

turns ON/OFF.

2 Turn the mode dial on the Case and confirm that the camera mode

switches properly.

• Check if the correct mode is being switched from the LCD monitor.

3 Press the shutter lever on the Case and confirm that the camera

shutter releases.

• Also operate other control buttons on the Case and confirm that the

camera functions properly.

Close the rear lid gently (so that the

O-ring does not slip out of the

groove), hook the buckle on the

edge of the rear lid, and tilt the

buckle lock/unlock lever in the

direction of the arrow to seal the

Case hermetically.

CAUTION:

• Seal the Case by turning both buckle lock levers down in arrow direction.

When one of the buckles is left open, the Case will not be sealed and water

leakage will occur.

• Close the rear lid of the Case so that the LCD hood and the lens cap strap

don’t catch. If they catch, water leaks may result.

PT-043_EN.book Page 19 Friday, December 7, 2007 5:30 PM

1 ... 56 57 58 ... 268

No comments

Olympus PT-043 User Manual Page 57