Olympus PT-E02 User Manual download pdf (Page 55)

E-14

How to connect the hot shoe cable

To perform TTL flash shooting using the Case, connect the hot shoe cable provided with

the Electronic Flash Case between the connector on the Case and the digital camera’s

hot shoe.

Turn the hot shoe cable connector cap inside the case

counterclockwise to remove it.

Insert the connector of the hot shoe cable into the case's

connector and turn the connector screws all the way

clockwise to connect them firmly.

Insert the hot shoe on the hot shoe cable into the hot shoe

on the camera.

When not using the hot shoe cable, attach the hot shoe

cable cap to the hot shoe cable connector inside the case

and turn the cap all the way clockwise to attach it firmly.

How to attach or remove the camera from the camera table

The digital camera is loaded and clamped in the Case by means of the camera table

located inside the front lid of the Case.

Turn the camera table clamping lever counterclockwise to

unlock it.

Slide the camera table out to the front.

To load the digital camera into the Case, insert the screw

of the camera table into the tripod screw hole on the

bottom of the digital camera and turn the screw clockwise

to secure it. For details, refer to "Attaching the digital

camera to the camera table" later in this manual.

Slide the camera table into the camera table base in the

front lid of the Case.

Turn the camera table clamping lever all the way clockwise

to clamp the camera table.

❈ To remove the camera, reverse the above procedure.

:•Be sure to remove the camera from the case when inserting the connector

of the hot shoe cable into the case’s connector.

CAUTION

1 ... 54 55 56 ... 284

No comments

Olympus PT-E02 User Manual Page 55