Olympus PT-E02 User Manual download pdf (Page 73)

E-32

Maintenance of the threaded sections on the

TTL cable and TTL cable connector

If the threaded sections used to connect the TTL cable to the TTL cable connector are not

maintained properly, salt and other seawater residue may adhere the TTL cable and

prevent it from being disconnected.

After use in seawater, clean off any salt, sand, or other residue as soon as possible, then

dry the equipment thoroughly. Clean the threaded sections with a cotton swab and apply a

thin, uniform layer of O-ring silicon grease (provided with this case).

Maintenance of the TTL Connector Cap

After removing the TTL connector cap from the waterproof cap, be sure to clean and

grease the O-ring.

Use the waterproof cap maintenance adapter to remove the O-ring unit from the

waterproof cap.

Waterproof cap Waterproof cap

maintenance adapter

Insert the adapter by aligning its pin with the hole on the

cap.

Turn the adapter counterclockwise to remove the O-ring

unit.

After removing the O-ring attached to the O-ring unit, clean

the O-ring groove and apply silicon grease to the O-ring.

Then, re-attach the O-ring to the O-ring unit.

❈ Reverse the removal procedure to re-attach the O-ring unit to the waterproof cap.

O-ring

Clean and apply O-ring silicon

grease to these sections.

1 ... 72 73 74 ... 284

No comments

Olympus PT-E02 User Manual Page 73