Olympus PT-E02 User Manual download pdf (Page 71)

E-30

6. Maintaining the Waterproof Function

Remove the O-ring.

Open the Case and remove the O-ring.

Procedure

Insert the O-ring remover into the gap between the O-ring and O-ring groove wall.

Bring the tip of the inserted O-ring remover below the O-ring. (Be careful not to damage

the groove with the tip of the O-ring remover.)

Lift the O-ring, pinch its with your fingertips and pull it out of the Case.

Remove any sand, dirt, etc.

After visually checking that dirt has been removed from the O-ring, checking for attached

sand and other foreign matter, as well as for damage and cracks can be done by squeezing

the entire circumference of the O-ring lightly with your fingertips.

Remove attached foreign matter from the O-ring groove with a clean cloth or a cotton swab.

Also remove any sand or dirt attached to the any part of the Case that comes into contact

with the O-ring.

:•When a mechanical pencil or a similar other sharp object is used to remove

the O-ring or to clean the inside of the O-ring groove, the Case and the O-

ring may be damaged and water leakage may be caused.

•When the O-ring is checked with the fingertips, take care not to stretch the

O-ring.

• Never use alcohol, thinner, benzene or similar solvents or chemicals

detergents to clean the O-ring. When such chemicals are used, it is likely

that the O-ring will be damaged or that its deterioration will be accelerated.

CAUTION

1 ... 70 71 72 ... 284

No comments

Olympus PT-E02 User Manual Page 71