112
Taking Multiple Exposures
With the camera in the sequential mode, press and hold down the shutter button to take
four rapid shots.
1
Set the mode dial to P, A, S, or M.
2
Press and hold down the drive
button
, and then turn the main
dial or sub dial until you see the
sequential mode mark appear
in the control panel.
3
Take the picture.
The camera will continue to shoot
exposures as long as you hold down the
shutter button. The camera will stop
shooting if you lift your finger from the
shutter button. The number of multiple
exposures is displayed in the control
panel.
Camera will not shoot after pressing shutter button?
blinking in the viewfinder?
If this mark is blinking, the built-in flash is charging. Wait for the mark to stop
flashing. After the flash is charged, the flash mark will light and remain
on.
and number of storable pictures blinking?
If the card error and the number of storable pictures is blinking, this means
the memory card is full. Replace the full card with another card, or delete
pictures from the full card that are no longer needed.
Sequential mode
mark
Control panel
Number of storable pictures
Number of multiple exposures
(Gauge shows 3 exposures)
3
1
2
ON
OFF
Comments to this Manuals