Olympus VT1621-01 User Manual download pdf (Page 189)

187

Problem Solution Page

Problem Solution Page

➞ 86

➞ 79

➞ 78

➞ 80

➞ 44

➞ 78

➞ 80

➞ 36

Is the flash mark displayed in the control

panel?

Is there strong light in the picture?

Was there something dark in the center of

the picture?

When the flash mark is displayed, the flash

will fire if the camera is in the fill-in flash mode,

even on a well lighted subject. Switch off the

flash mark, or close the built-in flash.

Adjust the exposure compensation or remove

the source of light from the picture.

If the center of the picture was dark, the

overall picture may appear too bright

whatever metering method you use. Try

switching to or center weighted

averaging metering , or you could use

spot metering by centering the subject

under the spot metering mark and then using

AE lock to achieve the correct exposure and

then take the shot.

Is the flash mark blinking in the

viewfinder?

Was the center of the subject very bright?

If the flash mark is blinking, this is a

warning that the subject is too dark and you

should use the flash. Use the flash.

If the center of the picture was very bright,

the overall picture may appear too dark

whatever metering method you use. Try

switching to or center weighted

averaging metering , or you could use

spot metering by centering the subject

under the spot metering mark and then using

AE lock to achieve the correct exposure and

then take the shot.

Pictures are too bright.

Picture is too dark.

Was part of the strap or one of your fingers

blocking the lens?

Make sure nothing blocks the lens when you

compose the picture.

Part of the picture is missing.

Problem Solution Page

1 ... 188 189 190 ... 202

Comments to this Manuals

No comments