Olympus VT1621-01 User Manual download pdf (Page 188)

186

Appendix 4: Troubleshooting (continued)

Pictures unsatisfactory

Problem Solution Page

Subject difficult to focus?

Did you release the shutter button and move

the camera?

Is the subject you want to shoot off center

from the AF target mark?

Is the lens dirty?

Is the macro setting correct?

Autofocus may not operate correctly for some

subjects. Follow the suggestions described in

“Difficult to focus subjects”.

If you move the camera while pressing down

the shutter button, the picture may be

blurred. This is called camera shake. Hold

the camera steady with both hands with your

elbows at your side and make sure your

fingers are down and grasping the camera.

Practice holding the camera correctly.

For autofocusing to work correctly you must

use the

AF target

mark. Position the subject

you want to focus in the center of the

viewfinder, or use auto lock focus.

Always store the camera in its case when it

is not in use. Clean the lens.

Did you stand in front of the camera when

you pressed the shutter button with the

camera in the self-timer mode?

If you stand in front of the camera and press

the shutter button, the camera will focus on

you. Compose the picture by looking through

the viewfinder and then press the shutter

button.

Is the flash mark flashing in the

viewfinder?

This is the flash warning telling you that

there is not enough light on the subject to

shoot the picture without the flash. Use the

flash.

If you are within 20~60 cm (0.7~2 ft.) from

the subject, the macro mark should be

displayed in the control panel. If you are

farther than 60 cm (2 ft.) from the subject

neither the macro mark nor the conversion

lens mark should be displayed. If the

conversion lens is attached to the camera,

only the conversion lens mark should be

displayed.

Pictures blurred, out of focus, not sharp.

➞ 66

➞ 38

➞ 38

➞ 65

➞ 9

➞ 42

➞ 133

➞ 113

➞ 44

1 ... 187 188 189 ... 202

Comments to this Manuals

No comments