Olympus VT1621-01 User Manual Page 84
- Page / 202
- Table of contents
- TROUBLESHOOTING
- BOOKMARKS
Rated. / 5. Based on customer reviews
82
7
Press the button.
This completes setting the camera for
autobracketing. In the control panel, you
will see BKT and the sequential mode
mark displayed. This confirms that the
camera is set for both autobracketing and
shooting multiple exposures. (When
shooting in the single-frame mode, hold
down the drive button and turn the
main dial or sub dial until you do not see
the sequential mode mark displayed in
the control panel.)
Press the button again to close the
menu.
8
Take the picture.
When the camera is set in the sequential
mode, press the shutter button once to
shoot three rapid pictures with the
exposure setting varied automatically for
each shot.
When the camera is set in the single-
frame shooting mode, you must press the
button once to take each picture with the
exposure setting varied automatically for
each shot.
Note
• The autobracketing setting is disabled and cannot be used in the following cases:
- When the mode dial is set to M (Manual mode)
- When the flash button is pressed and the built-in flash is raised.
• The mode dial setting determines which features are changed during autobracketing.
P Program mode. Shutter speed and aperture value adjusted.
A Aperture priority mode. Shutter speed adjusted.
S Shutter priority mode. Apeture adjusted.
• The shutter speed and aperture value display the adjusted exposure.
• If autobracketing (➞ 81) and exposure compensation (➞ 79) are selected together, then values
are calculated for both during shooting with autobracketing.
• If the camera is switched off suddenly during autobracket shooting, the camera will finish the
autobracketing shooting sequence after the camera is switched on again.
• Autobracketing will halt as soon as you release your finger from the shutter button and resume
shooting the remaining pictures after you press the shutter button again.
• With the camera set in autobracketing, you cannot select the self-timer mark , or the remote
control mark . To select these marks, release the camera from autobracketing with the menu.
• If you select autobracketing while the self-timer mode or the remote control mode is set, both
modes will be automatically released.
7
Control panel
Autobracket
setting mark
Sequential mode
Sequential mode selected
automatically when
autobracketing is selected.
Bracketing a Shot with Three Automatic Exposures (continued)
- Instructions 1
- CAMEDIA E-10 Features 4
- How to Use This Manual 5
- IMPORTANT SAFETY INSTRUCTlONS 6
- WARNING! 7
- Handling Batteries 7
- WARNING 8
- CAUTION 8
- Handling the Camera 8
- Camera Care and Storage 9
- Handling 9
- Caring for Your Camera 11
- Contents 12
- Contents (continued) 14
- Important Parts and Names 16
- Control panel 18
- Viewfinder 19
- Getting Started 21
- Everything 22
- Attaching the Camera Strap 23
- Battery service life 24
- Do not remove 26
- If insulation seal 26
- Before loading batteries 27
- Taking Pictures 31
- Inserting a Memory Card 32
- Setting the Shooting Mode and 34
- Switching the Camera On 34
- Checking the Battery 35
- CompactFlash card 36
- Not Displayed 37
- Holding the Camera 38
- Pushing the Shutter Button 40
- Gently half-press the shutter 41
- Gently full-press the shutter 41
- If You Cannot Take a Picture 42
- not displayed displayed 44
- Shooting distance and range 45
- Using the Built-in Flash 46
- Flash working range 47
- Viewing Pictures (Playback) 48
- Cannot enter playback mode? 49
- Monitor blank? 49
- Enlarged display 50
- The main dial and sub dial 51
- Using the remote control 51
- Index display 51
- Protecting Pictures 52
- Deleting Single Pictures 53
- Switching the Camera Off 54
- Shooting Techniques: 55
- General Introduction 55
- Blurred Background) 56
- Subjects) 57
- (Daylight Synchro) 58
- Both in Focus 59
- Shooting Moving Subjects 60
- Shooting Close-up 61
- Shooting Night Scenes 62
- Distance and Focus 65
- Using Autofocus (AF) 66
- Difficult to focus subjects 68
- Moving subject 69
- Using Manual Focus (MF) 70
- Brightness (Exposure) 71
- Setting the Shooting Mode 72
- Adjusting the exposure 73
- Setting the Aperture Value 74
- Setting the Shutter Speed 76
- Manually 78
- Take the picture 79
- Digital ESP metering 80
- Spot metering 80
- Using Exposure Compensation 81
- AE Lock 82
- Exposures 83
- Changing the ISO Setting 85
- Using a Flash 87
- Selecting a Flash Mode 88
- Fill-in Flash 89
- Red-eye Reduction 89
- Red-eye 90
- Reduction 90
- Flash FL-40 94
- Using the flash with close-up 95
- Color and Quality 99
- Auto white balance 100
- Quick reference white balance 100
- Preset white balance 100
- White balance with a flash 101
- Monitor display 101
- Using White Balance 102
- Using Preset White Balance 104
- Compression 105
- Resolution 106
- Selecting Sharpness 108
- Selecting the Contrast 109
- Displaying the Histogram 110
- Taking Pictures: 113
- Special Features 113
- Taking Multiple Exposures 114
- Using the Self-Timer 115
- Approx. 3m (10 ft.) (outdoor) 116
- Remote mode focusing 117
- To cancel remote mode 117
- Using the Remote Cable RM-CB1 118
- (Optional) 118
- Using Time-Lapse Photography 120
- Actual time interval 122
- When you switch the camera on 123
- Setting the Warning Sound 126
- Month, Day, is displayed 128
- RAW Data Mode 133
- RAW Data Mode (continued) 134
- Attachment 135
- Playing Back Images 139
- Displaying Image Information 140
- Adjusting Monitor Brightness 146
- Managing Stored 147
- Pictures 147
- Cannot copy? 149
- Copying only selected images 150
- Deleting All Images 152
- On the arrow pad, press to 153
- Press the button 153
- Formatting a Memory Card 154
- Naming Image Files 156
- Selecting Pictures for 159
- Printing 159
- Copies for Printing 160
- Changing the number of copies 161
- To cancel print selection 161
- Setting Up Index Printing 164
- Index Printing 165
- Stamping 166
- DPOF format 168
- Transferring Pictures to 169
- Connection Kit 170
- Switching the card 171
- Windows 98, Windows 2000 172
- Windows 98, Mac OS 173
- Windows 2000 173
- Monitor Menus 175
- Setting after and 177
- Playback mode menu 178
- Print reserve mode menu 178
- Setup/connection mode menu 178
- Appendices 179
- Appendix 1: Specifications 180
- Appendix 2: Available Options 182
- Appendix 4: Troubleshooting 184
- Built-in flash does not fire 187
- Monitor difficult to see 187
- Pictures unsatisfactory 188
- Pictures are too bright 189
- Picture is too dark 189
- Colors are odd 190
- Date incorrect 190
- Control 192
- Monitor 192
- Viewfinder 192
- Explanation Solution 192
- Glossary of Selected Terms 193
- Design rule for Camera Files 194
- Electro Selective Pattern 194
- Digital Print Order Format 194
- Exposure Value 194
- Manual mode 195
- Program mode 196
- Shutter priority mode 196
- Tagged Image File Format 197
- Index (continued) 200
Related products and manuals for Photo Accessories Olympus VT1621-01
Photo Accessories Olympus PT-E02 User Manual
(284 pages)
(284 pages)
Photo Accessories Olympus PT-036 User Manual
(268 pages)
(268 pages)
Photo Accessories Olympus PT-043 User Manual
(268 pages)
(268 pages)
Photo Accessories Olympus PT-E05 User Manual
(284 pages)
(284 pages)
© 2020, manymanuals.com. All rights reserved. | 0.055 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals