25
1
Inserting AA Ni-MH (sold separately), Alkaline, or Ni-Cd
Make sure all the batteries in the set are the same type. Before inserting Ni-MH or Ni-Cd batteries,
make sure that they are fully charged.
1
Insert the batteries as described in
the previous section for lithium
battery packs (CR-V3). (➞ 23)
Insert the batteries into the battery case
with the polarity of each battery aligned
correctly as shown in the illustration.
Note
• The appearance of the actual monitor menu
display may be different from the illustrations.
Before loading batteries ...
Warning
Batteries with any part of the outer seal (magnetic insulation sheath) peeling off, or any battery split
along the seam, can leak, generate heat, or explode. Never use damaged batteries in the camera.
Store-bought batteries occasionally may be defective, with all or part of the magnetic insulation
sheath peeling off. Never use batteries in this condition.
These batteries cannot be used:
1
The negative electrode
(minus terminal) is flat and
only partially covered by the
seal (electrical insulation
sheath).
The negative electrode (the
minus surface) is flat and not
covered by the seal.
All of the seal (electrical
insulation sheath) is peeled
off (bare batteries).
Batteries with all or part of
the electrical insulation
sheath peeled off.
Part of the negative electrode
is protruding although not
covered by the seal.
You may notice a gap after
loading the AA batteries into
the holder, but this is
normal. The batteries will
make proper contact when
the holder has been
inserted into the camera.
Battery holder
Comments to this Manuals